What a great set. This review is only for the three piece table and chairs but we got the bench as well for a complete 4 piece set. Look for a separate review and instructions for the bench.Very well engineered. Paint was perfect.It went together easily although I did trade in their little open end wrench for one of my sockets which probably cut the time in half. Instructions are practically nil With just a few pictures but it is engineered so well that you can figure it out for yourself very easily without instructions.Table:1. Turn the top upside down and put the studs in the threaded holes to hold the legs. If you don't put the studs in upside down, there is an Allen wrench hole in the top of each stud so that you can use the supplied Allen wrench/screwdriver to screw them down very quickly.2. Put the legs on Over the studs and then washers and nuts loosely until everything is lined up.3. Put the center support ring on with screws, washers, and nuts (loosely). Again, sockets are very helpful.4. Check for alignment and then tighten all the nuts.Chairs:1. Turn the seat upside down and put the studs in the threaded holes to hold the legs. If you don't put the studs in upside down, there is an Allen wrench hole in the top of each stud so that you can use the supplied Allen wrench/screwdriver to screw them down very quickly.2. Put the legs on Over the studs and then secure with washers and nuts. Again, sockets are very helpful.3. Put studs in the chair back and secure to the seat with washers, and nuts.Enjoy!